wall plug

英 [ˈwɔːl plʌɡ] 美 [ˈwɔːl plʌɡ]

墙上插座



双语例句

  1. The wire snapped at the wall plug with a blue flash and the light fused
    墙上插头处的电线啪地发出一道蓝光,电灯的保险丝烧断了。
  2. The wire snapped at the wall plug and the light fused
    墙上插座的电线短路烧断了保险丝,电灯跟着灭了。
  3. It includes a uniquely designed wall socket and plug ( as well as socket adaptors for most traditional plugs used the world over).
    这个系统包括设计独特的壁上插座和插头(还包括适用于世界上大部分传统插头的转向插座)。
  4. Have to have their own independent wall plug.
    必须要有自己独立的墙上插座。
  5. A wall plug or screw anchor is a type of fixing used in building.
    壁塞是一种装修工具,用来安装在墙上,以安放螺丝。
  6. Elements should have their heating sections in the furnace chamber so that no portion of the heating section extends into the furnace wall or refractory plug.
    安装时应确保其发热部在炉腔内,没有超出炉壁或者难熔插栓的部分。
  7. The wall plug is broken, isn't it?
    墙上的插座坏了,不是吗?
  8. It is described in this paper how to get an adequate geometry of the piercing plug, including the taper length, nose thickness and the plug wall thickness, when conducting design of the said plug.
    前言:介绍了在顶头设计中,如何正确选择穿孔锥长、鼻端厚及顶头壁厚的几何尺寸。
  9. Once the resulting burr generated components will run into sharp components and holes in the wall or between the bottom of defects, will plug the workpiece.
    由此生成的毛刺一旦碰到锋利的部件就会在部件和孔的侧壁或底部之间产生缺陷,会堵塞工件。
  10. My wall has a hole in it. I have to plug it with some cement.
    我的墙上有个洞,我得用点水泥把它填上。
  11. A larger diameter with a relative thinner wall for an open-ended pile leads to a higher plug length.
    分析认为开口管桩直径越大管壁越薄,形成的土塞高度则越大。
  12. Calculation of wall thickness of thick wall tube drawn without plug by using zhou-zhou formula
    用双周数表计算空拔厚壁管的壁厚
  13. Among 21 cases of benign cystic teratomas, the wall plug was demonstrated in 16 cases, solid mass in 3 cases, fat-fluid level in 2 cases.
    21例良性者16例显示壁结节,3例为实质性肿块,2例见脂/液平面;
  14. Water plug was introduced and TTAB on the capillary inner wall could be dissolved into the water plug, which enhanced negative zeta potential of the capillary section.
    再以高差法引入水塞,吸附于毛细管壁的TTAB溶解到水中,使该段毛细管的zeta电势变负;
  15. The results show: at lower pressure ratio, heat transfer condition on the plug surface is the worst, peak values of pressure and temperature appear along the wall of plug nozzle, temperature and temperature gradient along the section of wall reach the highest.
    计算结果表明塞式喷管发动机在较低压比的工况下工作时,塞锥受热状况较为恶劣,塞锥壁面出现压强和温度的峰值,该截面内部的温度和温度梯度达到最大。
  16. The pressure distributions on the wall surface of the plug nozzle models with two different truncated length were measured under different nozzle pressure ratios and the schlieren photos of typical cases were taken.
    实验模型采用直排的点膨胀构型,实验测量了两种塞体长度的塞式喷管在不同压比条件下的表面压强分布,拍摄了典型工况下流场的纹影照片。
  17. Analysis on Tube Wall Thickness Accuracy Improvement Resulting from Modified Second-Piercing Mill of Φ 400mm Plug Pipe Plant
    Φ400mm机组二次穿孔机改造后钢管壁厚精度分析
  18. The experiment shows the wall shear stress and the Sherwood number follows an analogous law. Their minimum appears at the nose of gas plug, while their maximum appears at the bottom of gas plug.
    实验结果说明,壁面剪应力与Sherwood数的变化规律类似,在弹状泡顶部达到最小。
  19. Wall shear stress method integrates the plug flow displacing, the low speed displacing and the turbulent flow displacing methods in theory.
    壁面剪应力设计方法,从理论上把塞流顶替、低速顶替及紊流顶替技术统一起来。
  20. Non-uniform wall thickness of steel pipe rolled on plug mill
    自动轧管机组轧制钢管壁厚不均问题的研究
  21. Presented in the paper is a summary concerning the operational practice in manufacturing of extra-heavy wall seamless steel tubes with Φ 100mm plug pipe mill.
    总结了在Φ100mm自动轧管机组上生产特厚壁无缝钢管的经验。
  22. Linear deformation zone of generating wall can be obtained by means of non-linear cone angle plug combined with the barrel-shaped rolls, so the wall accuracy can be increased greatly.
    采用带有非线性顶头锥角的顶头与桶形辊相配合可以获得线性的成壁变形区,从而大大提高壁厚精度。
  23. The process schedule to improve non-uniform shell wall thickness on plug mill is investigated.
    研究了在自动轧管机上减小荒管壁厚不均的工艺方案。
  24. Improvement of non-uniform longitudinal wall thickness in tube-rolling on a φ 140mm plug mill
    减小φ140mm自动轧管机组轧管的纵向壁厚不均

英英释义

noun

  1. receptacle providing a place in a wiring system where current can be taken to run electrical devices

      Synonym:    wall socketelectric outletelectrical outletoutletelectric receptacle